DESCRIPTION

The 1051S is more than prepared to feed a big, power-hungry subwoofer all it can handle; this beast pumps out an amazing 1050 watts RMS in bridged mode, and includes a Punch Bass boost of up to 18 dB at 45 Hz! A handy wired remote for the Punch Bass comes right in the box, so you can boost the boom right from the driver's seat.

• 265 watts RMS x 2 at 4 ohms
• 525 watts RMS x 2 at 2 ohms
• 1050 watts RMS x 1 at 4 ohms in bridged mode
• 4-ohm stable in bridged mode
• stereo or bridged mono output
• Tri-Way capable
• requires 4-gauge power and ground leads plus a 100-amp fuse and fuse holder — wiring and hardware not included with amplifier
• variable 50-250 Hz high-pass/low-pass crossover, 24 dB/ octave
• TOPAZ noise-killing differential inputs eliminate 80% of ground loop noise between the head unit and the amp
• NOMAD advanced protection circuitry monitors temperature, voltage, current and impedance, and provides "intelligent" shut-down protection without limiting system performance
• TRANS•ana circuit designs keep voltages low and signal paths simple in the pre-amp section, for minimum distortion and maximum musicality
• MEHSA provides more efficient transfer of heat from MOSFET output devices to the heatsink for cooler operation preamp outputs
• Punch Bass boosts bass up to 18 dB at 45 Hz (wired remote control included for fingertip control)
• 17-1/8"W x 2-3/8"H x 9-7/8"D